32490 MPE Software SW: AL Sched: pick sync error All The recorder has detected an impossible autoloader situation. This is likely due to autoloader commands issued via the diagnostic monitor while workstation images are active. The recorder has been automatically reset to re-synchronize. If this error is reported and no autoloader diagnostic monitor commands have been issued since the last few plates, report this error to the responsible firmware programmer. The recorder has been reset and should recover automatically. In any case, report the error to Creo Service. Autoloader diagnostic monitor commands issued while images active. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:17 2008 PST